Vendor Specific SMART Attributes with Thresholds: SMART Attributes Data Structure revision number: 16 SMART overall-health self-assessment test result: PASSED SMART support is: Available - device has SMART capability. SATA Version is: SATA 3.1, 6.0 Gb/s (current: 6.0 Gb/s) User Capacity: 1,000,204,886,016 bytes ĭevice is: Not in smartctl database ĪTA Version is: ACS-3 T13/2161-D revision 5 Smartctl 6.5 r4318 (local build)Ĭopyright (C) 2002-16, Bruce Allen, Christian Franke, = START OF INFORMATION SECTION = The entry (F) in this example shows that the partition is marked as ~]# smartctl -iHAl error /dev/sda
In the following example, a defective disk is still mounted in the ~]# cat /proc/mdstat The unmounted partitions of the hard disk sdb indicate that there is an error or a defect with this hard ~]# cat /proc/mdstat You can recognize this also by the entry.
The respective partition located on the second hard disk sdb is not mounted. In the following example, all logical drives have only one partition mounted, which is located on the sda hard disk. A U means that the respective disk is mounted (up) in the RAID. In the line listed below the respective logical drive, the state of the individual partitions is shown at the end of the line in the square brackets. For each of these logical drives, it is indicated which partitions they are composed of and on which drives these partitions are located.Įxample: The logical drive md0 is composed of the partitions sda1 and sdb 1. The above example shows three multiple devices or logical drives (md0, md1, md2). If both disks are present and mounted correctly, the following message is ~]# cat /proc/mdstat
#Softraid add new disk to raid array software
To check the status of the software RAID, enter the following command in the ~]: cat /proc/mdstat
0 kommentar(er)
